ProJet Tail Cutters (3)

Dual Tail Cutter (Tail and Deckle Cutter) for Wet Section

Automated trim removal before the couch and size press
Eliminates changing deckle widths of suction and press rolls
Substantial savings in drying energy possible if trim is removed at the wet-end instead of after the reel

Adjusting the paper width to cross directional shrink => Minimum paper loss at pope roller.
Parameter feedback: “End of production run” or “All parameters ready to go for new production run” => Unproductive time between production runs is minimized.
Setting the Tail width => Quickest possible adjustments.
Choosing the position of the Tail => Best position of the press rolls or press felts.
Choice for dual speed => Optimal speed for “Go to full width” and thus minimizing the risk for sheet breaks.=> Highest possible speed at “Cut off” and thus reducing scrap to a minimum.
Remote control => Operating personnel does not need to wait at the forming section during tail transfer => reduction of labour.